In such cases use universal remote control. In some cases the Software file is saved from the same board but the remote control may not match. if verifies successfully then resold it again and check.
After it write the given TOSHIBA 32L2400ZE LED TV Software and then verify after completion. Installation Instructions:įor writing Software file in TOSHIBA 32L2400ZE LED TV board, first of all save the backup of old dump then erase the flash chip. In this case if fault diagnose in power supply and can be repaired then no need to load Software file the TV will be normal after repairing and if the standby light is indicating and the TV not leaving standby or not responding remote and also all the primary and secondary voltage of the main board of the TOSHIBA 32L2400ZE LED TV are tested and found accurate then write Software file, hope the issue will be resolved by rewriting flash memory. If both are found ok and TOSHIBA 32L2400ZE LED TV is still dead then check the primary power circuit if found ok then test the secondary power circuit. In start check the fuse of main input if available then also check the power cable/wire continuity because in case of short circuit mostly the fuse burnt and cut off the supply. Mean no power no flash light or indicator then first check the physical damage/burnt area, short circuit then power supply. If the TOSHIBA 32L2400ZE LED TV does not turn on mean not leaving the standby position or the remote control is not responding and even the control buttons/keys on LED TV not working then Software file can be loaded. TOSHIBA 32L2400ZE LED TV Software file is shared for repairing purpose.
0 kommentar(er)
